JR ProPo C.O.L.T., Operation Manual

Page: 35 / 82

34
ᴾ
▋ Flap System【FLAP SYSTEM】
▋ Function Explanation
The flaps can be controlled in two stages using a switch. A flap delay is also possible.
Additionally, there is a function that carries out mixing to the elevators or and ailerons. There is also an Auto
Throttle function that automatically lowers the flaps when the throttle stick is lowered.
▋ Setting Method
If the flap channel output has not been set to “SYS” in the Device Select menu, the function will be displayed as
being unusable. To use this function, set the flap channel to “SYS”.
Set each Flap position in Normal and Land positions. If required, set a numeric value for the delay function.
Delay function(DELAY)
It is possible to adjust the transition timing between Normal (NORM) and Land (LAND) position.
Flap position switch (SW)
This is the switch to change the Flap position between Normal and Land.
※ Note that this is exactly the same setting procedure as in Device Select under the system list, where the Flap
channel input is selected.
Auto Throttle Function (AUTO THRO)
By activating “AUTO THRO”, the flaps are automatically lowered depending on the throttle stick position. Set the
throttle stick at the desired position and press the dial to display the box confirm the position.
Above the point where “AUTO THRO” has been set, “NORM” mode is selected. Below this point the flaps should
be automatically activated to the desired position.
Correction mixing for Elevator and Aileron.
In order to off-set the pitching action upon activating the flaps, it is possible to set a mix to elevator. It is also
possible to set a correction in roll by mixing to the Ailerons when the flaps are deployed.
▋ Caution Note
Actually operate the servos and carefully confirm the settings before flying.
Airplane
Function List
Correction mixing to the
Elevator and Aileron
Flap Switch
Movement Delay Time setting
Auto Throttle Function
(AUTO THRO)