KEYFREE TRANSMITTER
Carrier frequency
433,92 MHz
Modulation
AM/ASK
N° channels
1
E.r.p.
1 mW
Battery type
CR123A
Operating voltage
3 Vdc
Current consumption
12-15 µA : stand-by
20 mA : transmission
Battery life
2 years
Security protocol
Code combinations
2exp64
Range in open space
200/400 m
Operating temperature
-20°/+80°C
Enclosure IP grade
IP55
Dimensions (mm)
60 x 90 x 25
Weight ( gr. )
93
KeeLoq® Hopping code
2 - TECHNICAL SPECIFICATIONS
1 - INTRODUCTION
The Erone Keyfree transmitter is a special radio transmitter
operating at 433,92 MHz in AM/ASK modulation. It’s mainly
composed by a capacitive touch sensitive circuit and by a radio
transmitter. It can be used to operate gates or garage doors or any
device with the corresponding compatible 433 MHz receiver.The
security protocol is a rolling code type.
Each product is already factory programmed with a different
security code. The button is battery supplied with a CR123A lithium
battery for 2 year life. The enclosure protection grade IP55 allows
outdoor installations.The product fully complies to the
requirements of the European Directives 73/23/CEE,
89/336/CEE, 99/05/CE.
Use and installation manual
Thank you for choosing this product .
You are recommended to read this manual carefully before
installing this product.
IS-FKTERUK Rev. 0 del 26/03/2008
ERONE is a trademark by ELPRO INNOTEK Spa
Via Piave, 23 - I-31020 S.Pietro di Feletto (TV) - ITALY
Tel.: +39/0438/450860 - Fax.:+39/0438/455628
E-Mail: [email protected]
Web: www.erone.com
WARRANTY
The guarantee period of all Erone products is 24 months, beginning from the
manufacturer date. During this period, if the product does not work correctly,
due to a defective component, the product will be repaired or substituted at
the discretion of the producer. The guarantee does not cover the plastic
container integrity. After-sale service is supplied at the producer's factory.
Mounting screws
Plugs
CR123A
Lithium Battery
Lift to remove
battery
3 - INSTALLATION PHASES
4 - OPERATE
The Button operates when you skim over the external surface with
the hand. The sensitivity of the detector can change according to
the fixing surface type: metallic surfaces increase the sensitivity but
can reduce the range of the radio transmission. Approach the
cover or touch it until the buzzer sounds.The RF transmissions lasts
all time the buzzer sounds. Normally it’s necessary to skim over the
cover with the hand and not only with a single finger.
Touch sensitive
area
RF Antenna
Buzzer
The appliance uses a lithium battery type CR123A. Insert the new
battery on the battery location, respecting the right polarity. The
removal and the disposal of the battery must have effected before the
elimination of the appliance and according to the current Regulations.
ATTENTION: - Danger of explosion if the battery is not replaced in the
correct way! Replace only with an equal or equivalent type.
5 - BATTERY REPLACEMENT
1. Locate the best position for the installation, avoiding metallic
surfaces that could decrease the RF transmission.
2. Using the box bottom as a template mark the position of the
4 mounting holes.
3. Drill the mounting holes and insert the plugs.
4. Assemble base and seal together, install to mounting surface
using 4 screws.
5. Install the module to base and secure with the screws.
FKT2641E1
