6
2 INSTALLATION
!
WARNING
l
To guarantee the safe operation of the equipment it must be installed and commissioned properly by qualified
personnel in compliance with warnings laid down in these operating instructions.
l
Take particular note of the general and regional installation and safety regulations regarding work on high
voltage regulations, as well as the relevant regulations regarding the correct use of tools and personal protective
gear.
l
Make sure that the unobstructed clearance for each of the cooling inlets and outlets above and below the inverter
is at least 100mm.
l
Make sure that a space of 40mm is kept free at the sides of the inverter to permit the cooling air to escape from
the side slits.
l
Ensure that the temperature does not exceed the specified level when the inverter is installed in cubicle.
l
Avoid excessive vibration and shaking of the equipment.
l
Do not be obstruct the cooling fan that installed on the inverter, it is used to build proper airflow for heat sink
thermo dissipation. And do not touch the fan hole
when
it is running.
NOTE: Please consider the possible use of options, such as RFI suppression filters at the planning stage.
!
CAUTION
1) To open the upper cover of the inverter, follow these rules :
2) Cut off the input supply power
3) Wait 5 minutes until internal capacitor completely discharged
4) Use small
minus screw driver, plug into the lock holes located at the lower edge of the cover. Then the cover
is free to open.
2.1 Outline Dimensions
112.5
125
17
0
15
7.
5
154.5
Ø
5.5
PDx - 2007
、
2015
、
4015
10.0
0
170.0
157.6
19
3.
6
152.2
10.0
20
6.
0
Ø 5.5
PDx - 2022
、
2037
、
4022
、
4037
42
0
250
248
226
10.0
40
0
Ø
8.0
PDx - 2110
、
2150
、
2225
、
4110
、
4150
、
4225
30
0
178
190
Ø 6.0
192
28
6
30
0
PDx - 2055
、
2075
、
4055
、
4075
10.0