www.jps.com.tw
44
BP2P (Basic Point to Point) Group < Refer to chapter -14.4>
No.
Name
Default
Min.
Max.
Unit
Type *W
404 P2P FORWARD Travel Limit
1000000.000 -1000000.000 1000000.000
mm
R/W
2
406 P2P REVERSE Travel Limit
-1000000.000 -1000000.000 1000000.000
mm
R/W
2
411 (M) Productivity (Sheet Per Minute)
0
0
65536
SPM
M
1
413 P2P Specify STATUS for DO check
0
0
65535
FR/W
1
415 (M) P2P STATUS for Monitor
0
0
65535
M
1
416 (M) P2P Machine Position(mm)
0.000
-1000000.000 1000000.000
mm
M
2
426 (M) Motor Travel Length(mm)
0.000
0.000
1000000.000
mm
M
2
428 (M) P2P MARK Position(mm)
0.000
0.000
1000000.000
mm
M
2
430 P2P MARK-Window
5
1
30000
mm
FR/W
1
431
P2P ARC(Auto-Registration-Control)
Ratio
25
0
100
%
FR/W
1
432
P2P ARC(Auto-Registration_Control)
Limit
5.0
1.0
100.0
mm
FR/W
1
478 (M) P2P Cycle End Position
0.000
-1000000.000 1000000.000
mm
M
2
*W：mean 1 word or 2 word of parameter 。
9.4 Parameter Type
The table showed below describing the different type of all the parameter of this manual:
Type
Description
R/W
The parameter is Readable and Writable， and can be stored in EAROM.
FR/W
The parameter is Readable and Writable， and can be stored in EAROM.
This type of parameter is specially set by Factory and not for user normally usage.
This type of parameter only can be modified by authorized person.
RAM
The parameter is Readable and Writable， but it uses the RAM to temporally store the
change of parameter. After power on or reset it will be recover to be default value.
M
The parameter is Monitor type. Only readable and no effect for writing this parameter.
F
Factory set parameter， and should not be changed.
R
To indicate that any change of this type of parameter have to Reset the driver to enable
the change.
