www.jps.com.tw
89
※ 14.1.1.4 Speed Source Select=3【Speed Set from JOG Speed (Pr.259)】
Pr.259
JOG Speed Set
This parameter is JOG speed setting
。
※ 14.1.1.5 Speed Source Select =4【Speed Set from AI-1 ( 10V => Max Speed(Pr.203))】
【Note】
This speed is based on the read command source to Pr.119 (AI1 analog A / D conversion value),
which corresponds to Pr.203 (maximum motor speed), As is the speed command
。
Pr.132(AI1/AI2 AI1 & AI2 Range Select) suitable：0/1/2/3
【Description】
Assuming that the input voltage = 5V, and full scale = 10V,
Pr.203 (maximum motor speed) = 1000.0rpm
Then the current speed command = 500.0 rpm
Pr.117(AI1 Drift)
Pr.118(AI1 Gain)
Pr.119(AI1 Result Value)
AI1
Pr.132(AI1/AI2 Input Type)
Pr.249(Dec Ramp)
Pr.248(Acc Ramp)
Pr.250(S-curveT1)
Pr.251(S-curveT2)
Pr.252(S-curveT3)
Pr.253(S-curveT4)
DIx(10)：Speed Command SW0
-
DIx(11)：Speed Command SW1
DIx(12)：Speed Command SW2
I/O first
Pr.260(Speed Set0 (RAM)
Pr.267(Speed Set7 (EAROM)
TO
Pr.255(FWD/REV
Control Type)
Pr.203
(Motor Max Speed)
Pr.002：Speed Source Select
Match Pr.203(Max Speed)
SPEED BLOCK
Pr.002：Speed Source Select
Pr.255(FWD/REV
Control Type)
Speed Cmd
DIx(10)：Speed Command SW0
-
SPEED BLOCK
Pr.260(Speed Set0 (RAM)
I/O first
Pr.259
Pr.203
(Motor Max Speed)
Pr.249(Dec Ramp)
Pr.248(Acc Ramp)
Pr.250(S-curveT1)
Pr.251(S-curveT2)
Pr.252(S-curveT3)
Pr.253(S-curveT4)
DIx(11)：Speed Command SW1
DIx(12)：Speed Command SW2
Pr.267(Speed Set7 (EAROM)
TO
