JPS JMD-STD-90A, User Manual

Page: 116 / 149

www.jps.com.tw
115

Pr.411

(M) Productivity (Sheet Per Minute)
This parameter defines the amount of output per minute, the program based on the time
required to trigger the unit, converted the volume of production per minute 。
【Example】 P2P trigger after each travel time = 1000ms; therefore the number of outputs per
minute = 60000ms/1000ms = 60 (trips)

Pr.413

P2P Specify STATUS for DO check

Pr.415

(M) P2P STATUS for Monitor
This parameter defines the P2P stroke each state with the set value, the digital output via Dox
understanding in which a stroke.
About the trip status, refer to the following instructions ：
Status Description Memo
0 Inactive or P2P excitation or completed stroke
4 Ramp Up Zone
5 Constant Speed Limit Zone
8 Ramp Down Zone

Pr.416

(M) P2P Machine Position(mm)
This parameter defines: translated out of the motor rotation (length / position) values for
cumulative 。
【Note】 Whether or trigger P2P exciting itinerary, will be executed 。
Similar with Pr.478 。

Pr.426

(M) Motor Travel Length(mm)
This parameter is defined as the trigger P2P stroke (length / position) display value 。
【Note】 Both will be triggered every time: from 0 ~ Set stroke (mm) display 。

Pr.478

(M) P2P Cycle End Position
This parameter defines: Trigger P2P stroke (length / position), perform the cumulative operation 。
【Note】 P2P only trigger stroke (length / position), will perform 。
Similar with Pr.416。
When closing the excitation, and then trigger P2P stroke (length / position), this
parameter value will Pr.416 the moment, and then execute the cumulative 。
【Example】
Enable excitation ； P2P trigger length = 100 mm

Pr.416 =100 mm / Pr.478 =100 mm
Disable excitation ；Manually rotate motor 50 mm

Pr.416 = 150 mm/ Pr.478 =100 mm
Enable excitation ； P2P trigger length =200 mm

Pr.416 =350 mm / Pr.478 =350 mm