JPS JMD-STD-90A, User Manual

Page: 94 / 149

www.jps.com.tw
93

Pr.255

RUN/STOP/FOR/REV Command Type
Setting Description Memo
1 FWD / DIR
DIx(73)=FWD；DIx(74)=DIR
DIx(73)
Forward must be maintained, then DIx (74) direction only role.
2 FWD / REV
DIx(73)=FWD；DIx(74)= REV
DIx(73)
Forward and DIx (74) must be independent of the direction of
launch, if the two simultaneously activated to forward based.
14.1.2 Speed Mode：Standard Speed Mode：Digital Input

DIx _ Select

008，Zero Speed Holding
When this function is selected, the command execution speed to zero speed 。

DIx _ Select

010，Speed Command SW0

DIx _ Select

011，Speed Command SW1

DIx _ Select

012，Speed Command SW2
These groups of functions are used as paragraph 8 preset speed selector switch
In the speed setting 0 ~ 7 Preset speed, switch to the digital input 。
Speed selection bit 0 ~ bit 2 speed control mode selection table below ：
Pr.
Speed
Setting
Speed SW2
DIx(12)
Speed SW1
DIx(11)
Speed SW0
DIx(10)
Memo
260 Speed Set0 (RAM) 0 0 0
0：DI inactive
1：DI active
261 Speed Set1 (EAROM) 0 0 1
262 Speed Set2 (EAROM) 0 1 0
263 Speed Set3 (EAROM) 0 1 1
264 Speed Set4 (EAROM) 1 0 0
265 Speed Set5 (EAROM) 1 0 1
266 Speed Set6 (EAROM) 1 1 0
267 Speed Set7 (EAROM) 1 1 1

DIx _ Select

013，Cmd-OFF=AI1 ; ON=AI2(Use Pr.002=6)
When disabled, the running speed will perform AI1 = Pr.119 X 0.1 (rpm)。
When enabled, the running speed will perform AI2 = Pr.131 X 0.1 (rpm)。
【Note】The function suitable Pr.002=6(from AI-x ( Control by DIx(13)：AIxSW))

DIx _ Select

048，JOG Forward

DIx _ Select

049，JOG Reverse
When select DIx(048)，t he running speed will be JOG Forward 。
When select DIx(049)，t he running speed will be JOG Reverse。
【Note】JOG Speed Parameter = Pr.259。
When forward and reverse command is repeated, forward command priority