Jolly Mec FOGHEA, Installation, Use And Maintenance Card

Page: 19 / 48

19
1.7 New-generation simplified electronic controller
1.7.13 Lighting in wood mode
Before lighting the wood stove, a few preliminary operations are necessary:
1.
Clean the fire bed and empty the ash pan.
2.
Open the damper, turning the knob it until the notch is aligned with IIII (see
pag. 19
).
3.
Move the cast iron grate over the pellet burner.
4. Open the grille positioned on the ash pan.
5.
Open the Caldo Control by pulling the lever.
6.
Check that the controller is set to Winter mode (for heating, the corresponding LED must be lit).
7.
Check that the controller is set to wood mode otherwise the stove will light in pellet mode (the
corresponding LED must be lit).
8.
Press ON.
9.
Load the wood and light the fire.
10.
Close the door.
• Automatic switching from wood to pellet mode
With wood mode set, press the button
WOOD
again (the corresponding LED flashes) to activate
automatic switching from wood to pellet mode. When the wood is finished and the boiler water
temperature falls below the set limit, the burner starts automatically after 30 minutes.
For correct operation in wood mode, it is suggested to set
“SET
AIR WOOD” function to the value 2 in the Quick menu .
Fireplace output and load burn time are regulated by the
amount of combustion air; to adjust the amount, adjust the
primary air of the ash pan (opening or closing the grille).
The stove has an automatic draught adjustment by means
of the CALDO CONTROL (also adjustable manually), which
operates the damper to reduce the primary combustion air
passage when the air reaches a temperature of around 70°C.
To obtain a heating power of 23.2 kW, it is necessary to burn
6-7 kg of wood per hour.
Cast iron grate
Cast iron grate Caldo Control
Ash pan
BUTTONS
ON
w
inter wood
ON
on
IMPORTANT!
To switch automatically from wood to pellets, you need
to position the flue damper on III and it is required to
set the mode “
SET AIR WOOD “, in the quick menu on
the speed level 2.
Before making the final charge of wood, you should
remove, with the poker, the ashes laying on the
rear grid, this to allow the pellet flame to spread,
temporarily the burner can work with the grid lying
above the basket.
WARNING!
NEVER LIGHT THE STOVE IN WOOD MODE WITHOUT
THE POWER CONNECTED.