Jolly Mec FOGHEA, Installation, Use And Maintenance Card

Page: 9 / 48

9
1.6 Burner and pellet hopper parts
The JOLLY ME07 F burner and pellet hopper can be removed
for transport.
1.
Disconnect the power supply then detach the connectors.
2.
Loosen the hopper/burner connection clamp.
3.
Undo the two M8 screws inside the pellet hopper and remove
the hopper.
4.
Loosen the M6 locking screw on the burn pot container and
remove the pellet burn pot.
5.
Remove the ash pan.
6. Undo the M6 screws fixing the burner to the boiler and
remove the burner.
7.
Proceed in reverse order to refit.
To replace the ignition electrical element
1.
Disconnect the power supply then detach the connectors.
2. Undo the M6 screw and remove the protection casing.
3.
Undo the three M4 screws of the electrical element support
and remove the element.
4.
Proceed in reverse order to refit.
NOTE!
When refitting, make sure the electrical element is correctly
inserted in the special support fixed to the burn pot container
(when fixing with the screws, the flange must protrude
approx. 2 mm with respect to the face of the assembly plate).
Standard pellet hopper
Level sensor
(simplified electronic controller)
Hopper/burner connection
clamp
Air pressure switch
connection pipe
Protection casing Toothed wheels Assembly plate
removed
Plate removal
screws
Pellet feed control according to the various characteristics
Motor block
Screws fixing telescopic tube to boiler
Pressure switch fixing nut
Screws for fixing to telescopic tube support
Pressure switch support
Pressure switch
Burn
pot
Burn pot
locking screw
Burn pot
container
Electrical element
housing
Electrical element
Holder removal
screws
Telescopic tube
Safety
thermostat
Electrical
connection
Condenser
Combustion
air fan
Gear motor
Fan removal
screws
Fan support
Safety thermostat
Glass ventilation air
Release pin
Cotter pins
Electrical element
fixing screws
Fixing screws
Removable electrical element
support for facilitating fitting
and replacement
Standard pellet hopper weight 10,2 kg