1.13 Troubleshooting
If working with pellet the fireplace / stove does not lit, please
do the following instructions :
1.
Remove the burn pot, loosening the locking screw with the
wrench supplied or pliers.
2.
Clean and scrape the sides, clean all the holes.
3.
Clean the burn pot chamber.
4.
Refit the burn pot, paying attention to the pellet feed hole.
5.
Make sure the upper flange is perfectly positioned on the
support surface.
6.
Secure the burning pot with the locking screw using a
wrench or pliers by always checking the pot is perfectly
positioned on the support surface.
7.
Using the special key or a nail, make sure the hole in the
burn pot and in the hopper are aligned.
8.
Press the button
to manually load the fireplace until
the pellets start entering
9.
Before pressing the ignition button make sure the burn pot
is empty except for just a few pellets on the bottom (
F
ig
. 8
).
Never light the stove if there are more pellets.
The
STOVE can now be lit.
10.
Press the ON button on the electronic controller (
F
ig
. 9
) to
light the stove.
11.
On pressing the ignition button, the electronic controller
AUTOMATICALLY loads pellets up to 2 cm below the rim of
the burn pot (
F
ig
. 10
); the electrical element then starts the
pellet igniting stage.
IMPORTANT!
If the lighting cycle fails again, contact the Technical Assistance Service.
1.
2.
3.
4.
5.
6.
7.
8.
9.
11.
10.
28
For proper operation pellet combustion and to avoid problems, follow the instructions below.
Summary of Contents for FOGHEA
Page 46: ...46 Notes...
Page 47: ...47 Notes...
