Jolly Mec FOGHEA, Installation, Use And Maintenance Card

Page: 11 / 48

11
1.7 New-generation simplified electronic controller
1.7.2 Setting the language
To set the required language, when the operation status screen is displayed, press the button MODIFY
until ”LANGUAGE SET” appears .
Then use the buttons to select the required language.
> English
*
LANGUAGE SET
*
IT FR ESP ENG GER
1.7.3 Lighting in pellet mode, electronic controller
Before lighting the pellet stove, a few preliminary operations are necessary:
1.
Move the cast iron grate positioned over the pellet burner, uncovering it.
2.
Clean the fire bed and burn pot and empty the ash pan.
3.
Manually adjust the flue damper by turning the knob to the ideal position of draw. (see page. 19).
4. Make sure the pellets pot is well positioned (see par. 1.13 page 26).
5.
Make sure the ash pan is properly closed.
6.
Close the grille positioned on the ash pan.
7.
Close the Caldo Control by pushing the lever all the way.
8. Check that the electronic controller is set to Winter mode, otherwise the stove will not light (the
corresponding LED must be on).
9.
Check that the electronic controller is set to pellet mode, otherwise the stove will not light (the
corresponding LED must be on).
10.
If the electronic controller is in wood mode, set it to pellet mode by pressing the corresponding button.
11. Check that there are pellets in the hopper, otherwise top up with pellets of the recommended type (if
the pellets are below the level of the sensors, the stove will not light).
12.
Manual loading before lighting must only be done at first lighting and when cleaning the burn pot (do
not exceed the quantity indicated in F
ig
. 1 ).
In all other cases, DO NOT LOAD MANUALLY, because it is done automatically.
At first lighting and during lightings set with the chronothermostat, the damper
MUST
be opened in
HALF-CLOSED POSITION (II o III)
(see
pag. 19
).
Never light the fireplace if the quantity of pellets is more than that indicated in F
ig
. 1 .
NOW CARRY OUT THE LIGHTING STAGE.
On pressing the button for lighting, the electronic controller AUTOMATICALLY feeds the burn pot with
pellets up to 2 cm below the rim (as shown in F
ig
. 2 ); the electrical element then starts the pellet igniting
stage. If for any reason the pellet level is higher, when the electrical element starts ignition, remove the
excess pellets otherwise ignition may be violent.
NOW CARRY OUT THE LIGHTING STAGE.
Cast iron grate
Cast iron grate Caldo Control
Ash pan
2 cm
BUTTONS
F
ig
. 2
F
ig
. 1
ON
on winter
ON
pellets Off
=
manual loading
On
=
cleaning