Johnson & Johnson BPL II, Instructions For Use Manual

Page: 23 / 76

Operating Instructions
Attachments for Battery Reamer/Drill II
Instrument
530.705 Battery Reamer/Drill II
Precaution:
To prevent injuries, the mode switch of the drive unit
should always be in the “OFF” position when inserting
or removing attachments and cutting tools.
Please observe the safety instructions and warnings
stated in the instructions when working with attach-
ments. Only use original Synthes attachments.
Damage resulting from the use of attachments from
other manufacturers is not covered by the warranty.
Insert attachment
Insert the attachment into the coupling of the Battery
Reamer/Drill II, aligning the positioning pins of the at-
tachment with the grooves on the attachment release
ring (Fig. 1).
Turn the attachment release ring in the direction of the
arrow and push the attachment until it engages in
place (Fig. 2). If the attachment does not engage
properly then rotate the attachment gently until the
drive shaft engages.
Check that the attachment coupling is closed properly
by lightly pulling the attachment.
Remove attachment
Turn the attachment release ring in the direction of the
arrow and remove the attachment.
Note:
Properly functioning tools are essential to the success
of an operation. For this reason, used tools must be
checked for wear and/or damage after each use and
replaced if necessary.
Figure 1
Figure 2
Battery Power Line II Instructions for Use
DePuy Synthes
21