Johnson & Johnson BPL II, Instructions For Use Manual

Page: 49 / 76

8. Automated cleaning cycle parameters
Note:
The washer/disinfector should fulfill requirements specified in ISO 15883.
Step Duration (minimum) Cleaning Instructions
Rinse 2 minutes Cold tap water
Pre-wash 1 minute Warm water ( ≥ 40°C); use detergent
Clean 2 minutes Warm water ( ≥ 45°C); use detergent
Rinse 5 minutes Rinse with de-ionized (DI) or purified water
(PURW)
Thermal processing 5 minutes Hot DI water, ≥ 93°C
Dry 40 minutes ≥ 90°C
9. Inspect device
Remove all devices from the washing basket.
Inspect the cannulations, sliding sleeves, etc. for
visible soil. If necessary, repeat the manual pre-
cleaning/automated cleaning cycle. Confirm that all
parts are completely dry.
Precaution:
Mechanical cleaning is an additional stress for power
equipment, especially for seals and bearings. There-
fore, devices must be properly lubricated after auto-
mated cleaning. Furthermore, the device must be
serviced at least once per year as specified under
the section “Repair and Technical Services” on page
58.
Battery Power Line II Instructions for Use
DePuy Synthes
47