Operating Instructions
Battery Reciprocator II (530.715)
Insert saw blade
Insert a reciprocating saw blade into the coupling
and push until the saw blade locks in place (Fig. 1).
Lightly pull the saw blade to ensure it is properly
seated.
Adjust sawing plane
Pull the sliding sleeve back and rotate the saw head
to adjust the sawing plane (adjustable through 360°
in 45° increments, Fig. 2).
Release the sliding sleeve and turn the saw head
slightly until it locks in place.
Figure 1
Remove saw blade
Turn the release knob in the direction of the arrow to
eject the reciprocating saw blade (Fig. 3).
Instructions for handling saw blades
DePuy Synthes recommends using a new saw blade
for each operation to ensure that the saw blade is
optimally sharpened and clean.
The following risks are associated with used saw
blades:
Figure 2
-
Thermal necrosis caused by excessive heat build-
up
-
Infection caused by residues
-
Extended cutting time due to poor sawing per-
formance
-
Potentially, splintering of the teeth or the saw
blade
The use of irrigation fluid is recommended to cool the
cutting tools and prevent heat necrosis.
Check the cutting tools for wear and / or damage
after each use, and replace if necessary. These are
optimized to meet the specific requirements of the
tool. Non Synthes saw blades can considerably re-
duce the lifetime of the system.
Figure 3
Detailed ordering information on saw blades for the
Battery Power Line II system can be found in the
brochure “Saw Blades” (036.000.197).
38
DePuy Synthes
Battery Power Line II Instructions for Use
Summary of Contents for BPL II
Page 2: ......
Page 4: ...2 DePuy Synthes Battery Power Line II Instructions for Use...
Page 75: ......
