JCM Part No. 960-000097R_Rev. 3
© 2010, JCM American, Corporation
4 - 1 0
Section 4
Universal Bill Acceptor (UBA-1x-SS & UBA-x4-SS/SU)
Disassembly/Reassembly
2. Remove Lower Sensor Spacer upward and
slide it sideways out of Transport Guide C in
the direction of the large arrow shown in
Figure 4-29.
3. Rotate the 2nd Mover Gear in the direction
indicated by the arrow shown in the Figure
4-29 exploded view inset.
4. Remove Mover Guide Assemblies #1 and #2
out of each side of Transport Guide C
(See Figure 4-29).
5. Push Pulley Shaft #2 out of the assembly in
the direction indicated by the arrow shown in
Figure 4-30a.
6. Remove the Mover Pulley up and out of the
assembly while Pulley Shaft #2 is withdrawn
from the assembly (See Figure 4-30 b).
7. Remove the two (2) E-Clips securing the
ends of the Mover Worm Gear Shaft
(See Figure 4-30 c).
8. Pull the Mover Worm Gear Shaft out of the
assembly along with the Final Mover Gear,
Parallel Pin and E-Clip attached to it.
9. Push each end of the three (3) Pulley Shafts
out one at a time as illustrated in Figure 4-31
(a), and move their respective pulleys to the
side wall.
10. Push the end of the Pulley Shaft in, and pull
it out in the direction indicated by the arrow
shown at the Figure 4-31 (b) location.
11. Lift the two (2) freed Transport Pulleys up
and out of the assembly (See Figure 4-31 c).
Figure 4-28
Timing Belts Removal
Figure 4-29
Mover Gear #1 & #2 Removal
Caution: When re-inserting Mover
Guides #1 and #2, ensure that they have
an identical sized spacing width (A=B)
when being simultaneously reinstalled
inside Transport Guide C (See Figure 4-
29
).
Figure 4-30
Pulley Shaft Removals
Figure 4-31
Mover Worm Gear Shaft Removal