JCM Part No. 960-000097R_Rev. 3
© 2010, JCM American, Corporation
2 - 3
Installation/Operation
Universal Bill Acceptor (UBA-1x-SS & UBA-x4-SS/SU) Section
2
Connector Pin Assignments
Table 2-2 through Table 2-5 list the various UBA Connector Type Pin Assignments. Table 2-2 lists the
UBA-10/11/12 Rear Panel Connector Pin Assignments, Table 2-3 lists the UBA-14 Rear Panel Connector
Pin Assignments and Table 2-4 lists the UBA-24 Rear Panel Connector Pin Assignments.
Table 2-2
UBA-10/11/12 Rear Panel Connector Pin Assignments
UBA-10/11/12 Rear Panel Connector
Pin
No.
Signal Name
*
*. Signal name, I/O, and function without parenthesis are for ID-003 interface.
I/O
†
†. I/O (input/output) is the terminal viewed from Banknote Acceptor’s side.
Function
1
+12V POWER
+12V DC power
2
GROUND (Power)
0V DC Ground Plain
3
M. RES
In
Bill Acceptor master reset signal line
4
PC/RS232C OUT
Out Serial data signal output line from Acceptor to Controller
5
+12V I/F
+12V DC Interface Power
6
PC/RS232C IN
In
Serial data signal input line from Controller to Acceptor
7
GND I/F
Photo-coupler Zero (0) Volt DC Interface power
8
(TTL1)
(In) Reserved (TTL1) input
9
(TTL1)
(Out) Reserved (TTL1) output
10 (TTL2)
(In) Reserved (TTL2) input
11 (TTL2)
(Out) Reserved (TTL2) output
12 (TTL3)
(In) Reserved (TTL3) input
13 GND
RS232C 0 Volt DC Interface power
14 LED POWER
LED drive line - anode
15 (TTL4)
(In) Reserved (TTL4) input
16 (TTL5)
(In) Reserved (TTL5) input
17 (TTL3)
(Out) Reserved (TTL3) output
18 LED- (TTL4)
(Out) LED Drive Line - cathode (TTL4)
19 (TTL5)
(Out) Reserved (TTL5) output
20 (TTL6)
(Out) Reserved (TTL6) output
Socket Jack: DRA-20PC-FO (JAE)
Contact Type: D02-22-26P-10000 (JAE)
Socket Plug: DRA-20SC-FO (JAE)
Contact Type: D02-22-26S-10000 (JAE)
NOTE: Photo-coupler and RS-232C signal level isolation can be jumper selected using
jumpers located on the CPU board. The related jumper selections are described in
“Jumper Configurations” on page 9 and page 10 of this Section.