JCM Part No. 960-000097R_Rev. 3
© 2010, JCM American, Corporation
4 - 6
Section 4
Universal Bill Acceptor (UBA-1x-SS & UBA-x4-SS/SU)
Disassembly/Reassembly
12. Use Needle-nose Pliers to disconnect the
Encoder Sensor Board Harness Connector
Plug from the internal Circuit Board through
the frame access hole as shown in the
exploded view inset in Figure 4-14 a.
13. Remove the Final Stacker Gear E-Clip and
remove the Gear (See Figure 4-14 b).
14. Turn the UBA Acceptor Unit upside-down a
fourth time.
15. Remove the four (4) right side Frame
Mounting Screws indicated in Figure 4-14 c.
16. Remove the two (2) Transport Gear Cover
retaining screws (See Figure 4-15 a), and
remove the Transport Gear Cover from the
Acceptor Unit assembly.
17. Remove the last remaining left side Guide
Mounting Screw (See Figure 4-15 b).
18. Pull the Transport Opening Lever to open
Transport Guide D. The Unit will separate
into three pieces consisting of Transport
Guide A, Transport Guides B & C, and
Transport Guides D & E respectively
(See Figure 4-16).
Transport Guides B & C Disassembly
Perform the following steps to disassemble UBA
Transport Guide B from Guide C:
1. Remove
the
Final
Transport Gear E-Clip and
remove the Final Transport Gear and a Paral-
lel Pin located below it (See Figure 4-17 a).
2. Remove the 3rd Transport Gear as illustrated
in Figure 4-17 b.
3. Remove the Lower Sensor Board as previ-
ously described in the section discussing
“Lower Sensor Board Removal” on page 4-4
of this Section.
4. Remove the mounting screw securing
Grounding Plate #2 (See Figure 4-18 a) and
the three (3) Guide B mounting screws to
separate Transport Guide B from guide
Section C (See Figure 4-18 b).
Figure 4-15
Last Left Side Guide Mounting Screw
Removal
Figure 4-16
UBA Side Frame Removals
Figure 4-17
UBA Guide B Removal