janitza UMG 96-PA, User Manual And Technical Data

Page: 34 / 84

UMG 96-PA / UMG 96-PA
MID
www.janitza.com
34
12. Configuration
To configure the device, connect the supply
voltage. For this purpose, proceed as described
in 13.1 on page 43.
NOTE
The configuration of the UMG 96-PA
MID
is
password protected (cf. „14.7 Password
configuration“ on page 65).
·If you are not in the measured value display
“ OvervFew ”, switch to this view by pressing key
1 (Esc) several times.
·Press key 1 (Esc) to open the main menu.
With keys 3 (

) and 4 (

) select the “ System ”
and confirm your selection with key 6 (Enter).
·Select “Configuration” and confirm the
selection with key 6 (Enter).
12.1 Communication
In the configuration menu, set the parameters for
the RS485 interface of your device.
·Open the configuration menu (see chapter 12
“ ConfiiuratFon ”).
·Using keys 3 (

) and 4 (

) select the menu
item “ CommunFcatFon ”.
·Confirm using key 6 (Enter).
·Using keys 3 (

) and 4 (

) select the desired
parameters
- Device address,
- Baud rate
- Data frame.
· Confirm the selection using key 6 (Enter).
·Change the parameter values with keys 3 (

)
and 4 (

) .
Device address: Using keys 2 (

) and 5 (

) set
the number position.
·Confirm using key 6 (Enter).
·Close the
“CommunFcatFon” menu by pressing
key 1 (Esc).
·Exit the configuration menu by pressing key 1
(Esc).
·Press key 1 (Esc) to open the main menu.
·Select the desired measured value display with
keys 3 (

) and 4 (

) . Confirm the selection
with key 6 (Enter) or navigate directly to the
measured value display
“OvervFew” by pressing
key 1 (Esc).
12.2 Language
In the configuration menu, set the desired
language for the measured value displays and
menus under “
Laniuaie ”.
·Open the configuration menu (see chapter 12
“ ConfiiuratFon ”).
·Using keys 3 (

) and 4 (

) select the item
“ Laniuaie ”.
·Confirm using key 6 (Enter).
·Confirm the selection using key 6 (Enter).
·Exit the configuration screen by pressing key 1
(Esc).
·Press key 1 (Esc) to open the main menu. Select
the desired measured value display with keys 3
(

) and 4 (

). Confirm the selection with key 6
(Enter) or navigate directly to the measured value
display
“OvervFew” by pressing key 1 (Esc).
Fig. ConfiiuratFon menu, “CommunFcatFon” selectFon
Fig. ConfiiuratFon menu, “Laniuaie” selectFon
Fig. MaFn menu, “System” selectFon
Using the keys 3 (

) and 4 (

) select the
desired language (“ German” , “ EnilFsh ”).