Iwatsu ADIX VS, Technical Manual

Page: 73 / 136

63
Chapter 1
••
ADIX-VS Installation
This section describes the installation of the ADIX-VS system. Inspect all system components before
beginning the installation process.
VS-KSU
The VS-KSU is powered by an internally mounted VS-PWSU power supply. It contains dedicated
card slots for the VS-CPU/MEM card,three trunk interface cards, two station cards, and two
universal card slots. In addition, it provides jacks for 6 digital stations, 2 single line stations, an
external MOH source, and two serial ports.
The table below lists the components shipped with the VS-KSU.
Component Quantity
VS-KSU 1
ADIX KT Programming Overlay 1
Wall Mounting Screws 4
User's card 1
)
Assembly
1. Loosen the two screws on each side of the front panel.
2. Remove the front panel from the VS-KSU.
3. Insert the circuit card into each slot. Make sure to insert each card until the connectors snap
into place.
4. Secure the FG bracet on the card with a screw.
5. Secure the card stopper bracket on the motherboard(VS-MAIN) with the four screws if no
other cards are to be installed.