Iwatsu ADIX VS, Technical Manual

Page: 94 / 136

ADIX-VS Technical Manual Section 3 – ADIX-VS Installation
84
VS-MISC Card Port Assignment and Function
The table below lists the default function of each circuit on the VS-MISC card:
Card Slot 7
Circuit
Physical
Port Logical Port Number Function
1 105 Miscellaneous Logical 003 Page Zone1
2 106 Miscellaneous Logical 004 BGM Source
3 107 Miscellaneous Logical 005 Not used
4 108 Miscellaneous Logical 006 Relay Control
5 109 Miscellaneous Logical 007 Sensor Input
6 110 Miscellaneous Logical 008 Page zone 2
7 111 Miscellaneous Logical 009 Not used
8 112 Miscellaneous Logical 010 Not used
Preparation
1. Set the option switchs on the VS-MISC card according to the desired function.
2. Set SW2A,SW2B,and SW2C to either 4-wire or 2-wire depending on type of paging amplifier
used.
3. Set BGSW to USED if BGM through paging amplifiers is desired. If not, set to UNUSED
4. Set SWBG1-SWBG2 to output BGM through page zones 1-2 as desired.
5. Using a screwdriver, adjust VR1 to set the BGM output volumes.
Installation
1. Plug the card into any universal card slot. Make sure that the card is inserted deep enough for all
connector pins to make complete contact with those on the motherboard (VS-MAIN).
2. Secure the FG bracket on the FG plate with a screw.
3. Secure the card stopper bracket on the motherboard(VS-MAIN) with the four screws if no other
cards are to be installed.