Isgus PERFECT 2030, Operating Manual

Page: 31 / 138

Chapter 3 Installation 3-11
2) Connect wiring for audible signal circuit control.
→
only if required.
→
low power signal output: 15V DC , 50 mA
Attention
This connection is polarity sensitive.
Wrong connection causes a damage of the unit!
3) Connect wiring for synchronized clock option
→
only if the recorder is equipped with the option module "MASTER CLOCK".
→
fused output rated at 12 V, max. 50 mA,
This connection is not polarity sensitive.
4) Connect an optional battery pack for printer operation
during a power failure.
1. Put the battery pack into the prepared battery
partition.
→
the battery partition is on the left side on the
bottom of the case.
2. Unplug bridge (Z-Diode, 12 V / 1 W) at clamp X5 of
the PC board of the unit.
→
Hint: Keep the Z-Diode on hand. The z-diode
must be replaced, when removing the battery
pack.
3. Connect the cables of the battery pack to clamp X5
of the PC board of the unit. + = red - = black
Attention
This connection is polarity sensitive.
Wrong connection causes a damage of the unit!
The Installation is now finished.
To program the time recorder see chapter 4 "Getting Started".
If the recorder is to be programmed at a later date, insert the front cover and close
the recorder.
NC
- O
U
T
+
3
4
5
12