Isgus PERFECT 2030, Operating Manual

Page: 84 / 138

4-52 Getting Started Chapter 4
Quit Programming Mode
After quitting the menu item "Master Clock" with the "
S " key, the programming
routine is terminated. The recorder automatically carries out an initialization routine
during which it sets up the new program(s).
After having completed the initialization routine, the current date and time are
displayed.
Hint
The programmed functions are only valid after a minute change.
Now the recorder is ready for operation.
Make a sample punch on a blank time card and check the print. If date and time are
not correct, please start the date and time program routine and reset. (See section
"Date / Time " at the beginning of this chapter).
If you want to print out all program settings, you can start now. Insert a blank card
and proceed as if programming the time recorder by calling-up the programming
routine. Continue as described under "Print out of Program Settings" in this chapter.
Commissioning after Power Failure
All time recorder programming is stored in non-volatile memory. In addition, the
correct time and date is maintained by a long-life battery, mounted on the CPU
board.
Therefore, the time recorder never needs to be reprogrammed after a power failure.
Normal operation of the clock should automatically resume when power is restored.
As a precaution however, after a power failure check the recorder and make a
sample punch with a blank time card.