Intel SR1530 - AHJPCIERISER PCI-E x8 Riser Card, User Manual

Page: 99 / 184

Intel
®
Server System SR1530AH / SR1530AHLX / SR1530HAHLX 77
Replacing the Power Supply (SR1530HAHLX)
Caution: The power supply is NOT hot swappable. Before removing or replacing the power supply,
you must first take the server out of service, turn off all peripheral devices connected to
the system, turn off the system by pressing the power button, and unplug the AC power
cord from the system or wall outlet.
The power supply can be replaced if it fails or if one of the fans that is integrated into it
fails. To replace the power supply, use the following instructions.
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” on page iii .
2. Power down the server and unplug all peripheral devices and the AC power cable
(see letter “A” in the figure below).
3. Remove the server system cover. For instructions, see “Removing the Server
System Cover” .
4. Disconnect all power cables connected to the server board and peripherals.
5. Lift up slightly on the front of the power supply until it clears the foot at the bottom
of the chassis (see letter “B” in the figure below).
6. Slide the power supply forward (see letter “C” in the figure below) and then lift it
from the chassis.
Figure 70. Removing Power Supply from the Server System (SR1530HAHLX)
C
A
AF0016 3 0
B