Intel SR1530 - AHJPCIERISER PCI-E x8 Riser Card, User Manual

Page: 79 / 184

Intel
®
Server System SR1530AH / SR1530AHLX / SR1530HAHLX 57
Installing or Removing a Slimline Optical Drive
(SR1530HAHLX)
Caution: The optical drive is NOT hot swappable. Before removing or replacing the optical drive,
you must first take the server out of service, turn off all peripheral devices connected to
the system, turn off the system by pressing the power button, and unplug the AC power
cord from the system or wall outlet.
Installing a Slimline Optical Drive (SR1530HAHLX)
Note: The hardware necessary to install your optical drive was shipped to you in a bag labeled
“CD-ROM Assy”.
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” on page iii .
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see “Removing the Server
System Cover” on page 28 .
4. Remove the bezel if it is installed. For instructions, see “Removing the Front
Bezel” on page 26 .
5. First time installation only: Remove the peripheral knock-out by rocking it back
and forth.
6. Attach the optical drive attachment bracket as shown in the figure below.
Figure 53. Attaching the Optical Drive to the Attachment Bracket
7. Slide the optical drive assembly in through the front of the chassis (see letter “A” in
the figure below).
AF00164 3
A