Intel SR1530 - AHJPCIERISER PCI-E x8 Riser Card, User Manual

Page: 66 / 184

44 Intel
®
Server System SR1530AH / SR1530AHLX / SR1530HAHLX
13. HDD1 only: Route the power cable into the cable clip on the top of the hard drive
bracket. See letter “A” in Figure 35 .
14. Connect the data cables to the drive(s).
— If a drive is installed in the HDD0 carrier, connect the HDD0 data cable to the
SATA 0 connector on the server board. See letter “B” in
Figure 35 .
— If a drive is installed in the HDD1 carrier, connect the HDD1 data cable to the
SATA 1 connector on the server board. See letter “C” in
Figure 35 .
Note: The data cables are factory routed underneath the fan module. Use caution to make sure
you connect the connect cables between the server board and the hard drives. The cables
are labeled at each end.
15. Connect the power cables to the drive(s):
— If a drive is installed in the HDD1 carrier, attach the connector on the daisy
chain power cable that is closest to the power supply to the HDD1 connector.
See letter “E” in
Figure 35 .
— If a drive is installed in the HDD0 carrier, attach the middle connector on the
daisy chain power cable to the HDD0 power connector. See letter “D” in
Figure 35 .
Figure 35. Connecting Hard Drive Power and Data Cables (SR1530AH/
SR1530AHLX)
16. Install the server system cover. For instructions, see “Installing the Server System
Cover” .
HDD 1
0
1
B
B
AF001173
C
C
D
A
HDD 0
E