Intel SR1530 - AHJPCIERISER PCI-E x8 Riser Card, User Manual

Page: 67 / 184

Intel
®
Server System SR1530AH / SR1530AHLX / SR1530HAHLX 45
Removing a Hard Disk Drive (SR1530AH/SR1530AHLX)
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” on page iii .
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see “Removing the Server
System Cover” on page 28 .
4. Disconnect the power and data cables from the drive.
5. HDD1 location only: Slide the power cable from the cable clip that is located on the
top of the hard drive carrier.
6. Remove the screw that holds the hard drive bracket to the chassis. See letter “A” in
the figure below. Save this screw. You will use it to reinstall the drive assembly
later.
7. Lift the drive carrier from the chassis. See letter “B” in the figure.
Figure 36. Removing Drive Carrier from the Server System (SR1530AH/
SR1530AHLX)
8. Remove the four screws that attach the hard drive to the drive carrier. Lift the drive
from the carrier. Store the drive in an anti-static bag.
9. If you are installing a new drive, skip the rest of these steps and instead see
“Installing a Hard Disk Drive (SR1530AH/SR1530AHLX)” on page 41 , beginning
with step 8.
10. Insert the screws that held the drive in the carrier into the screw locations on the
carrier for future use.
AF001050
B
A
Chassis
Front