Intel SR1530 - AHJPCIERISER PCI-E x8 Riser Card, User Manual

Page: 63 / 184

Intel
®
Server System SR1530AH / SR1530AHLX / SR1530HAHLX 41
6. Reinstall and reconnect any parts you removed or disconnected to reach the
processor sockets.
7. Install the server system cover. For instructions, see “Installing the Server System
Cover” .
Installing and Removing a Hard Drive
(SR1530AH / SR1530AHLX)
Caution: The hard drives are NOT hot swappable. Before removing or replacing a hard drive, you
must first take the server out of service, turn off all peripheral devices connected to the
system, turn off the system by pressing the power button, and unplug the AC power cord
from the system or wall outlet.
Up to two SATA drives can be installed. The HDD0 drive bay is at the left side of the
chassis, underneath the optional CD-ROM drive. The HDD1 drive bay is at the right side
of the chassis. The drives do not need to be installed in order; HDD1 can be installed
before HDD0.
Note: The server system does not support all hard drives. See “Server System References” on
page x for an Internet link to a list of supported hardware.
Installing a Hard Disk Drive (SR1530AH/SR1530AHLX)
Note: If you are replacing an hard drive, see “Removing a Hard Disk Drive (SR1530AH/
SR1530AHLX)” on page 45 for instructions first. Return to these steps when directed.
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” on page iii .
2. Power down the server. Unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see “Removing the Server
System Cover” on page 28 .
4. Locate the drive position you want to use. See Figure 31 .