Intel SR1530 - AHJPCIERISER PCI-E x8 Riser Card, User Manual

Page: 87 / 184

Intel
®
Server System SR1530AH / SR1530AHLX / SR1530HAHLX 65
5. Remove the screw at the rear of the riser assembly. See letter “A” in Figure 61 .
Save this screw. You will reinstall it later.
6. If a filler panel is installed over the opening at the rear of the riser assembly lift it
from the riser assembly. See letter “B” in the figure. Save the filler panel in case
you later need to remove the add-in card.
7. Insert the add-in card into the socket in the riser assembly. Push the add-in card into
place firmly until it seats in the riser card connector, but use caution so you do not
twist or bend the card. See letter “C” in the figure.
8. Re-install the screw you removed in step 5. See letter “A” in the figure.
Figure 61. Installing an Add-In Card
9. Install the PCI riser assembly into the server system. For instructions, see
“Installing the PCI Riser Assembly” on page 61 .
10. Install the server system cover. For instructions, see “Installing the Server System
Cover” .
11. Plug all peripheral devices and the AC power cable into the server.
Removing a PCI Add-in Card
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” on page iii .
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see “Removing the Server
System Cover” on page 28 .
4. Remove the PCI riser assembly. For instructions, see “Removing the PCI Riser
Assembly” on page 60 .
B
C
A
AF000674