Intel SR1530 - AHJPCIERISER PCI-E x8 Riser Card, User Manual

Page: 109 / 184

Intel
®
Server System SR1530AH / SR1530AHLX / SR1530HAHLX 87
9. Turn the bracket over and remove the two screws that attach the failed fan to the
bracket. Save these screws. You will reinstall them later. See letter “A” in the figure
below.
10. Lift the fan from the bracket. See letter “B”.
Figure 80. Removing Fan from Fan Bracket (SR1530AH / SR1530AHLX)
11. Install the replacement fan onto the bracket, using the two screws you removed in
step 9.
12. Set the fan assembly into the system. Insert the rear edge first and push the
assembly slightly rearward to clear the hard disk drive brackets. Use caution to
make sure you do not pinch any cables.
13. Route the cable from the fan at the right around the right side of the assembly and
under the clip at the front of the fan bracket.
14. Connect the fans to the server board. See letters “A” and “B” in the following
figure.
AF000963
A
B