Intel SR1530 - AHJPCIERISER PCI-E x8 Riser Card, User Manual

Page: 82 / 184

60 Intel
®
Server System SR1530AH / SR1530AHLX / SR1530HAHLX
Installing and Removing the PCI Riser Assembly
Caution: The PCI riser assembly is NOT hot swappable. Before removing or replacing the PCI
riser assembly, you must first take the server out of service, turn off all peripheral devices
connected to the system, turn off the system by pressing the power button, and unplug the
AC power cord from the system or wall outlet.
Removing the PCI Riser Assembly
To remove the PCI riser assembly, use the following instructions.
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” on page iii .
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see “Removing the Server
System Cover” on page 28 .
4. Disconnect any cables attached to any add-in cards.
5. Lift riser assembly up to remove it. Use caution to gently easy the riser card from
the add-in card slot so you do not damage the slot or the riser card. See Figure 57 .
Figure 57. Removing PCI Riser Assembly from the Server System
6. If you need to add or replace a PCI riser connector, see “Installing or Replacing a
PCI Riser Card” on page 62 .
AF000673