Intel SR1530 - AHJPCIERISER PCI-E x8 Riser Card, User Manual

Page: 56 / 184

34 Intel
®
Server System SR1530AH / SR1530AHLX / SR1530HAHLX
Figure 23. Installing the Processor Air Duct (SR1530HAHLX)
Installing and Removing Memory
Caution: The memory is NOT hot swappable. Before removing or replacing any memory DIMM,
you must first take the server out of service, turn off all peripheral devices connected to
the system, turn off the system by pressing the power button, and unplug the AC power
cord from the system or wall outlet.
The silkscreen on the board for the DIMMs displays DIMM A1, DIMM A2, DIMM B1,
and DIMM B2 starting from the center of the board. See
“Memory” on page 17 for a
discussion of the memory requirements and options. See “Server System References” on
page x for a link to the list of tested DIMMs.
Installing DIMMs
To install DIMMs, follow these steps:
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” on page iii .
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see “Removing the Server
System Cover” on page 28 .
AF001581