Page 27
EN
Chapter 6 Installation
6 Installation
Observe the following notices when assembling and posi-
tioning the machine:
!
DANGER
If the
inoCOMB Picco Power is operated by unqualified
individuals, this could put the life and health of the
operating staff at risk and cause property damage to
the inoCOMB Picco Power or other assets.
!
DANGER
Rotating mixing shafts.
Danger of death due to being pulled into the machine
and crushed.
When the motor is running, the mixing shaft rotates
in the material hopper!
• Do not reach into the rotating mixing shaft.
• Do not place any objects into the rotating mixing shaft.
1. Before working on the metering and mixing shaft, inter-
rupt the external power supply (main switch off). Loos-
en the screw of the protective screen above the material
hopper only when the machine is switched off.
2. Pull out the mains plug.
3. Secure the machine against unexpectedly being switched
back on.
!
DANGER
Pressurised conveyor hoses.
Risk of injury and risk of property damage due to es-
caping and/or flying material, and/or bursting con-
veyor hoses.
• Before disconnecting the conveyor hoses, make sure that
the hoses are depressurised. To do so, check the pressure
indicator on the mortar pressure gauge. The pressure in-
dicator must display 0 bar!
• Before opening the hose coupling, let the inoCOMB
Picco Power run in reverse to reduce any pressure!
• Use only conveyor hoses which are permissible with an
operating pressure of 40 bar and a burst pressure of 120
bar, and are in a technically perfect condition (e.g. are
without any cracks or other external damage!).
Installation location requirements
• Ensure that there is enough space around the machine
to enable filling of the material hopper and machine op-
eration.
• Install the inoCOMB Picco Power on an even and hori-
zontal surface.
• Prevent the machine from sliding by locking the front
wheels. The mixing zone points downwards.
• Cover the floor underneath the machine with a plastic
sheet, if it is not on a firm, tarmacked surface.
• Keep the machine in a dry, protected area in wet weath-
er.
• Prevent direct exposure to sunlight, especially while in
continuous operation, in order to prevent the motor
from overheating.
6.1 Delivery condition of the machine
The inoCOMB Picco Power is shipped with the mixing zone
pre-assembled and the motor flange-mounted. The pump
unit (rotor/stator/pressure gauge) must be attached to the
mixing zone by both tie rods.
6.2 Assembling the pump unit
Assemble the pump unit (rotor/stator/pressure gauge) with
both tie rods at the lower end of the yellow mixing zone.
Summary of Contents for inoCOMB Picco Power
