Installation and Programming Manual
Options and programming methods
75
•• Inhibit (bypass) control panel zones
•• Activate (unbypass) control panel zones
•
Shortcut option
- field for the selection of the parameter relating to the
shortcut.
•
Shortcut 2
- field for the selection of a second shortcut which is to be
activated the one selected previously (as above).
•
Shortcut option 2
- as per “Shortcut option” but applies to “Shortcut 2”.
•
Feedback
- identifies the type of command feedback.
••
SMS
- feedback will be provided by an SMS text to the telephone number
of the caller (command dispatcher).
Positive outcome: <SMS Text>: “done”
Negative outcome: <SMS Text>: “failed”<Cause>
<Cause> is the explanation of failure to carry out the command.
••• “Invalid code”
••• “Invalid terminal”
••• “Terminal already in the requested status”
••• “Code not enabled”
••• “Zone not ready”
••• “Unbypassable zone”
••
Ring
- feedback is provided on the telephone of the caller (command
dispatcher). Positive outcome is indicated by a “ring”; negative outcome is
indicated by no “ring”.
Note
Both SMS and Ring feedback occur only when the caller's telephone number is available
(caller number not hidden).
••
Buzzer
- feedback is provided by an audible signal on the Nexus buzzer.
Positive outcome is indicated by a three short audible signals; negative
outcome is indicated by five long audible signals.
COMMAND USING SMS
TEXT
Users who wish to activate a command via SMS text must enter the command
details as follows:
<xxxxxx> <SMS Text>
where:
•
<xxxxxx> stands for the user-access PIN
•
a blank space must be keyed in after PIN entry
•
<SMS Text> which is the command identifier, as previously described
EXAMPLE
You wish the control panel to activate “Scenario 3”, switch On the perimeter lights
and confirm the operation via SMS text. For an operation of this type, proceed as
follows:
1. “SMS Text” - choose the desired description, for example “Night mode”
2. “Shortcut” - select the “Arm/Disarm” shortcut
3. “Shortcut option”: “Scenario 3”
4. “Shortcut 2” - select the “Activate outputs” shortcut
5. “Shortcut option 2” - the output associated with the perimeter lights
6. “Confirm” - SMS
When a user keys in the following SMS text on a mobile (cellular) phone:
123456 Night mode
where “123456” stands for the User's access PIN and this message is sent to the
number of the SIM card of the Nexus, the control panel will carry out the
requested operations and will send confirmation to the mobile phone of the caller
who dispatched the command.
DEFAULT COMMANDS
The installer by modify the five predefined default commands:
•
“
CREDIT
” for balance enquiries relating to the SIM card of the Nexus - the
user will receive an SMS text indicating the remaining credit.
•
“
STATUS
” for status enquiries relating to the Nexus - the user will receive an
SMS text indicating the:
•• device name and firmware revision
•• GSM network provider
•• GSM signal reception level
•• device tamper status
•• BUS status
•• Balance (remaining credit)
