62
Options and programming methods
Installation and Programming Manual
•
AnnounceShortcut -
(for JOY/MAX keypad only) if enabled, after PIN entry
followed by
, the voice guide will announce the available shortcuts for the
user-code concerned and the respective number keys on the keypad.
Note
Set the “Loc.KpadMess Time” (refer to paragraph
6-25 Other parameters
) to allow the
system to play the messages associated with all the shortcuts assigned to number keys
, ...,
.
•
Remote access -
if enabled, the code PIN can be used to operate the system
from any remote telephone.
If the code PIN is entered on a remote telephone keypad, only the shortcuts
associated with keys 0 to 9 can be used to:
•• Arm/Disarm
•• Stop alarms
•• Clear call queue
•• Delete memory
•• Activate outputs
•• Deactiv. outputs
•• Listen-in
•• Arming status
Any other type of command will have no effect.
•
Patrol
- if enabled, the code will be able to disable the system for the pre-set
“Patrol time”.
Func.KeyShortcuts
This section allows you to programme up to 12 shortcuts associated with keys
, ...,
. After valid PIN entry followed by
, the keypad will show the
icons that correspond to shortcut keys
, ...,
.
Press the corresponding
key to activate the respective shortcut.
0/9 Key shortcuts
This section allows you to programme up to 10 shortcuts associated with keys
, ...,
. After valid PIN entry followed by
, the user will be able to
activate specific shortcuts by means of the number keys.
To assign the shortcuts to the function keys, work through the following steps.
1. Use key
or
to select the key you wish to associate with the shortcut
then press .
2. Press
then
use key
or
to select the shortcut you wish to associ-
ate with the key from the “Type” list.
3. Press
to confirm and exit.
4. If the shortcut is associated with “Arm/Disarm” operations, the application
will ask you to select a scenario. If the associated shortcut is “Activate out-
puts” or “Deactiv. outputs”, the application will ask you to select an output.
Assigned outputs
This section allows you to enable/disable the outputs the code user can control
manually via the
User Menu>Outputs ON/OFF
.
1. Use keys
and
to select the desired output.
2. Use keys
and
to enable/disable manual control of the output for
the code concerned.
3. Press
to confirm and exit.
Timers
This section allows you to assign a timer to the code. The code will be operative
only at the pre-set times.
Enable/disable
This section allows you to enable/disable access to the various sections of the
User Menu.
For further details regarding the User Menu, refer to the “User Menu” section.
The programming steps are identical to those of “Outputs ON/OFF”.
