Installation and Programming Manual
Options and programming methods
71
6-24
User functions
This section describes the functions the installer has in common with the user.
Via Keypad
1. Access the “User functions” section:
Type-in Code
(Installer)
, PROGRAMMING User functions
.
2. Use keys
and
to select the User functions then press
.
View
•
Events log
- allows you to view all the events
saved to the log.
•
Alarms log
- allows you to view all the events
relating to zone/partition alarm
and tamper saved to the log.
•
Faults log
- allows you to view all the fault events saved to the log.
•
Arm/Disarm ops.
- allows you to view all the arm/disarm operations saved
to the log.
Use key
or
to scroll the chronological events list. For some events, key
allows you to view the partitions details. For example, the details of an “Arm”
command will show the code and keypad concerned and, if you press
, the list
of partitions involved.
•
Nexus status
- allows you to view (on the display) the following parameters
of the Nexus device:
1° line:
GSM network provider (Vodafone, etc.)
2° line:
GSM signal reception (value between 1 and 100)
3° line:
balance, at the last operation (expressed in the local currency)
4° line:
faults present; if faults are present, access the “View-Faults” section for
details.
•
System voltage
- allows you to view the voltage the system uses.
•
Zone status
- allows you to view the status of all the zones. Use key
or
to scroll the list of accessible zones.
The “Zone status” section allows you to view the zone status (“Standby”,
“Alarm”, “Shorted”, “Tamper”), the operating status (Unbypassed - able to
generate alarms, or Bypassed - unable to generate alarms) and also the
resistor value expressed in Ohm.
•
Faults
- allows you to view any current faults.
•
Panel version
- allows you to view the firmware version and model of the
SmartLiving control panel.
Outputs ON/OFF
Allows manual activation/deactivation of the outputs by means of keys
and
.
Set date/time
Allows you to set the date and time of the control panel.
1. Use key
or
to select the programming field you wish to change (hour,
minutes, etc.).
2. Use key
or
to change the value in the selected field.
3. Press
to save and exit.
Via PC
Installer Code
18:23 30/10/2011
KEYP. 001
VIEW
Events log
Alarms log
Faults log
PROGRAMMING
Messages
Default settings
User functions
User functions
View
Outputs ON/OFF
Set date/time
Table 41:
User functions - via SmartLeague software programme
Option
Part of the system
Template/section
View/Log
SmartLiving system - Log
Programming
Set date/time
SmartLiving System
Programming
