Ingersoll-Rand Schlage AMGtime G Series, User Manual

Page: 64 / 119

Command Menu Reference: Setup Menu
56
GT-400 Terminal User’s Guide
Go To StandAlone Mode/Network Mode
The display of this menu indicates the current
mode of the terminal.
Go To StandAlone Mode is only displayed when
the terminal is running in networked mode. To put
the terminal in standalone mode, press Go To
StandAlone Mode. When the terminal is in
standalone mode, no synchronization with the
host application will occur.
Go To Network Mode is only displayed when the
terminal is running in standalone mode. To put
the terminal in network mode, press Go To
Network Mode. When the terminal is in network
mode, the terminal will attempt to synchronize
with the host application.
Default: enabled
Ran g e: none
Dependencie s : none
Who: A network administrator can change
this setting at any time.
1 Log into the terminal as an administrator.
See “Administrator Authentication” on page 33 for more information.
2 Press Setup Menu.
3 Press Network Setup.
4 Press Go To StandAlone Mode/Go To Network Mode.
5 Press Go To StandAlone Mode/Go To Network Mode (again).
Set WebServer
Set WebServer enables or disables the web
server. If the terminal will be used in network
mode, the web server should be enabled. The
display of this menu will indicate the current state
of the web server. If disabled, press the Enable to
enable the web server. If enabled, press Disable
to disable it. Default: enabled
Ran g e: none
Dependencie s : The web server will not be enabled/
disabled until the terminal is
rebooted.
Who: A network administrator should set
WebServer during initial terminal
setup.
1 Log into the terminal as an administrator.
See “Administrator Authentication” on page 33 for more information.
2 Press Setup Menu.
3 Press Network Setup.
4 Press Set WebServer.
5 Press Enable or Disable.
6 Reboot the terminal.
See “Rebooting the Terminal” on page 41 for more information.