Ingersoll-Rand Schlage AMGtime G Series, User Manual

Page: 29 / 119

21
GT-400 Terminal User’s Guide Terminal Installation: Printer Setup (Optional)
Printer Setup (Optional)
You may want to install a printer to provide a paper receipt of each user booking. A booking is the
interaction that is recorded each time a user punches in or out of the terminal.
If you want to install a printer after initial terminal setup, you will need to shut down the terminal
first and then perform the following steps. See Shutting Down the Terminal for more information.
At the time this user's guide was printed, only the Epson USB Receipt printer is supported.
1 Connect the receipt printer to the terminal's USB port.
2 Power on the receipt printer.
The receipt printer must be powered on and connected to the terminal via the USB port before
the terminal is powered on.
After you have powered on and configured the terminal, perform the following:
1 Enable PrintBookings.
See “Set PrintBookings” on page 46 for more information.
2 Set the baud rate.
See “Set Baud Rate” on page 46 for more information.
3 Enable printing on the host application.
By default, the terminal will print the following on the receipt:
• Date and time of booking
• User name
• User's credential ID
• Verification result
• Punch status (in or out)
Configuring the Terminal
You must configure the terminal before completing installation.
Go to “Terminal Setup” on page 25. Follow the configuration instructions for your terminal (network or
demo mode).