Ingersoll-Rand Schlage AMGtime G Series, User Manual

Page: 36 / 119

Terminal Setup: Demo Mode Configuration
28
GT-400 Terminal User’s Guide
Demo Mode Configuration
When the terminal is started for the first time, the synchronization screen will be displayed. When
the terminal is not connected to a host application, synchronization will not occur and the terminal
should be switched to standalone mode. See “Go To StandAlone Mode/Network Mode” on
page 56 for more information.
1 Plug the P1 connector into the socket on the back board of the terminal.
2 Observe the terminal screen for messages indicating the terminal is searching for the host
application.
3 Press and then within three (3) seconds. If you do not perform this action, the terminal
will continue to start up.
4 Observe the terminal screen for the message “Starting Application…”. When the hand logo
disappears, the terminal is fully booted.
5 Press and then .
6 Press Set Host DBSync.
7 Press Disable.
8 Wait until the LED bar turns amber, indicating the terminal is fully booted and running in demo
mode.
9 Configure the following terminal settings:
• Set Locale Time Zone.
See “Set LocaleTimezone” on page 49 for more information.
• Set the date.
See “Set Terminal Date” on page 47 for more information.
• Set the time.
See “Set Terminal Time” on page 48 for more information.
ESC
ENTER
ESC
ENTER