Inficon UL6000 Fab, Translation Of The Original Operating Instructions

Page: 81 / 152

INFICON Operation | 6
UL6000-Fab,-PLUS-Operating-instructions-iinc75en1-01-(2206) 81 / 152
ü
There are no long hoses connected to the "purge gas connection". There, the air
enters the device whose helium concentration is measured. See also "Connections
for accessories and control signals [ } 31]".
ü
The device is in the "Standby" state.
1 Press .
2 Select “I•CHECK“.
3 Press .
4 View the measurement result.
See also
2 Connections for accessories and control signals [ } 31]
6.7 Measurement data
You can record measured values in the internal database. Recording can be done
automatically during the measurement or via the "Record measurement data" button
in the measurement screen.
See also "Switch on data recording and configure export [
}
81]".
You can also export the displayed measured values.
See also "Display measurement cycles [ } 82]".
For the export you can either use a USB flash drive or the network connection, see
also “Export measurement data via network [ } 83]”.
6.7.1 Switch on data recording and configure export
NOTICE
Reduces the service life of the memory
The recording of many measured values reduces the service life of the internal
memory.
► Disable data recording when you no longer need it.
ü
Operator or Supervisor rights
1 > Setup > Data recording
2 To record immediately after starting a measurement, activate the option
"Enabled".
Note: Data recording occurs during the measurements, i.e. while the
measurement screen is displayed. See also "Display measurement cycles
[ } 82]".
ð
This option is deactivated as standard. To start or stop a recording without
activating this option press in the measurement display.