IMO Jaguar CUB, Instruction Manual

Page: 71 / 170

4-2
4.1.3 Preparation before running the motor for a test--Setting function code data
Before starting running the motor, set function code data specified in Table 4.1 to the motor ratings
and your system design values. For the motor, check the rated values printed on the nameplate of
the motor. For your system design values, ask system designers about them.
For details about how to change function code data, refer to Chapter 3, Section 3.4 "Setting
the Function Codes." If the motor capacity is different from the inverter capacity, refer to
Chapter 5, function code H03.
Table 4.1 Settings of Function Code Data before Driving the Motor for a Test
Function code Name Function code data Factory setting
F 04
Base frequency 60.0 (50.0) (Hz) (Note)
F 05
Rated Voltage (at base
frequency)
0 (V)
(Output voltage interlocked
with the source voltage)
P 02
Motor Parameter
(Rated capacity) Applicable motor rated
capacity
P 03
Motor Parameter
(Rated current) Rated current of applicable
motor
P 99
Motor Selection
Motor ratings (printed on the
nameplate of the motor)
0: Characteristic of motor,
0 (standard 8-series
motors)
F 03
Maximum frequency 60.0 (50.0) (Hz) (Note)
F 07
Acceleration time 1* 6.00 (sec)
F 08
Deceleration time 1*
System design values
* For a test-driving of the motor,
increase values so that they
are longer than your system
design values. If the set time
is short, the inverter may not
start running the motor.
6.00 (sec)
(Note) Values in parentheses ( ) in the above table denote default settings for the EU version except three-phase
200 V series.