E211101X_rev02_ENG
29/06/2022
32
To replace the ironing bands, the upper protection should be used. Open the two side shoulders of the machine and
unscrew the pins connected to the draft eyelet of the bands. After completely loosening the old straps, remove them by
removing them and replacing them one at a time with the new bands.
Close the new bands, with the proper thread, above the introduction roller. Pinch one of the metal hooks at the end of
the band to prevent the wire from slipping off. Remember to insert the bands in the correct direction and direction
(weaving in Nomex outwards and covering the junction in the direction of rotation of the roller). Finally, tension the
ironing bands.
-
REPLACEMENT OF CONVEYOR BELTS IN NOMEX (if necessary):
For the replacement of the belts detach linen to remove the lid of the roller and proceed to replace the belts detaches
linen by knotting them or gluing them with the proper kit that can be requested from the manufacturer. Do not
overeating.
-
ROLLER CLEANING
If it is necessary to clean the chrome roller, use a brush with brass bristles.
ATTENTION!
Cleaning the machine is extremely important. The accumulation of fluff could generate the risk of developing a
fire!
35.
BURNER CLEANING (for gas Ironer)
ATTENTION!
There is a risk of injuring yourself or damaging the equipment. Any ordinary or extraordinary maintenance
must be conducted by professionally qualified personnel. Make sure all power supplies are disconnected before
performing any type of maintenance.
Open the left side with the proper key. Remove the suction regulator, loosen the fitting, and support screws. Remove the
ignition and flame detection glow plugs.
Remove the burner and proceed to clean the outer surface using a rag. Check that the holes are not clogged. In case of
partial or total obstruction of the holes proceed to cleaning.
Nonuse screwdrivers or sharp tools that could cause damage to internal components.
36.
WHAT TO DO IN CASE OF PROLONGED DOWNTIME
Cover the roller with paraffin after removing the top cover or close the roller with oiled paper.
