E211101X_rev02_ENG
29/06/2022
21
The temperature to be used must follow the temperatures allowed by the characteristic plates of the linen to be ironed.
Remember that at the end of the work, the machine cannot be stopped, at least until the temperature has dropped below
80 ° C.
Also remember that the moisture conditions of the fabrics must be no more than:
-
50%: for cylinders dryers
The drying Ironer must therefore be used on fabrics that have been centrifuged with a super centrifuge washing
machine. Its purpose is to dry and simultaneously iron the flat garments.
ATTENTION!
When the machine is not running, remember to disconnect
all
power supplies: electricity
and
gas, steam,
compressed air
.
21.
HOW TO USE COOLING
The cool down is a function that allows you to save and optimize the thermal energy accumulated in the machine. When
you are at the end of the work shift, or when you need to stop ironing, you can use such a function. Cooling is turned on
and off by pressing the
COOL Down
button.
When the function is activated, the thermoregulation is interrupted: the activated cooling signal slides on the display:
The roller continues to spin until the temperature drops below 80°C. Once this temperature is reached, the machine
stops completely.
If it is necessary to reactivate the thermoregulation, the cool down function can be deactivated, before reaching 80 ° C,
by pressing the COOL DOWN button
again.
In this way, the set point temperature is restored, and the work cycle can
be resumed.
22.
THE GAS RESET BUTTON
For machines with gas heating, there is a reset button on the push-button panel that allows you to restore any blocks of
the flame control unit.
If the igniter does not ignite the gas, the microprocessor signals the block through the "flame lack" display signal,
alternating with the invitation to press the RESET gas button.
