E211101X_rev02_ENG
29/06/2022
18
Rotate the flyer:
-
counterclockwise: to turn the roller in the direction of ironing and extract the linen stuck
At the same time, insert fabrics with the usual ironing methods, along the entire length of the roller, to lower the
temperature.
ATTENTION!
If the temperature of the roller is high (above 80°C), continue to insert wet fabrics over the entire length of the
roller, and continue to rotate the roller by hand, to avoid burning of the ironing bands.
18.
WORK CYCLE: VERIFICATION OF SAFETY SYSTEMS
After turning on the machine, before starting work, it is necessary to check the perfect functioning of the safety devices.
The operator must perform the following procedure each time the machine is started.
ACTION to be performed
REACTION to be obtained
Press the ON/OFF button on the digital keyboard
→
The cylinder MUST begin rotation.
Press the ON/OFF button on the digital keyboard
The cylinder MUST stop the rotation
Start the rotation of the roller: push the hand
protection.
Repeat the operation of pushing the hand protection
in at least three places: in the center and 50 cm from
the right end and from the left end.
→
In all three tests, the roller MUST stop: the SAFETY
RESET button MUST be switched on.
Start the rotation of the roller: take turns running the
right emergency buttons.
→
The roller MUST stop: the SAFETY RESET button
MUST turn on.
Once the preliminary operations of verification of the efficiency of the safety systems have been completed, it is
possible to start the ironing cycle.
ATTENTION!
All users must be informed of this procedure and be aware of the operation of the machinery's safety systems.
19.
USING THE EMERGENCY BUTTON
In case of emergency and need for a quick stop of the machine, press the emergency button on the side of the machine.
When the emergency button is pressed, the ironing roller stops at the same time the lay is lifted.
When the emergency has been resolved, rearm the emergency button, rotating it according to the indications on the
fungus itself.
Press the red RESET button to re-enable the operation of the machine.
Stop Category 1: Controlled stop with power available to the actuators to achieve shutdown and then power removal
when the stop is reached.
20.
START AND STOP
Turn on the machine by bringing the main switch, described in the earlier paragraph, to the "I" position.
Make sure that the emergency button is in the resting position, and that it has not been activated during transport or
before the last shutdown of the machine.
Before starting the machine, always perform the safety check procedure (check the relevant paragraph).
