Imesa MCM 2500, Use, Installation And Maintenance Instructions

Page: 14 / 33

E211101X_rev02_ENG 29/06/2022
14
3. Water/air separator
4. Safety valve at 12bar.
ATTENTION!
The safety valve must be dimensioned to provide to the maximum steam system capacity.
5. filter
6. steam inlet gate
7. condenser outlet
8. check valve
9. flow indicator
10. condenses exit gate
11. machine inside
12. external system
13. steam supply system
IN) steam entrance
OUT) condense drain
H2 (distance from the floor) referring to the Water/air separator (3) must be higher than H1 referring to the coupling (2).
The two quotes must differ at least of 30 cm.
13.
PED ROLLER INSTRUCTIONS
In the steam heated ironer, the roller is subject to the European Community 97/23 directive in matter of equipment
under pressure, usually called PED, because the cylinder is a pressure container of IV category.
Each roller is CE marked to confirm that it was evaluated for the conformity: a metal label explains its characteristics
(as well as the corrosion upper thickness value) and the serial number. This label is fixed on a lateral cover of the roller.
The roller mounting is operated by the manufacturer.
ATTENTION!
The roller working start is under installer responsibility. The installer must ask for the homologation. The safety
devices are not included in the machine supply.
It is necessary to remember that:
- roller max working pressure is 12 bar
- the entire system must be equipped with a safety valve, which must be sized respect on the entire system where
the ironer is installed: the installer is responsible for the valve working start and for the safety valve
maintenance. Dangerous situation must be avoided providing suitable safety devices.
- The installer must provide suitable control system to verify immediately possible working problems.
-
The installer must control if in the installation room gas or vapours may cause fire if they should enter in
contact with the heated surface.
- Each two year control the roller inside surface to verify corrosion level. The optic fibre video camera can be
insert using the roller air hole, as shown in the below picture: