imagistics im3510, Operation Manual

Page: 120 / 128

7-10
KEY OPERATOR PROGRAMS
■
Device settings
{Device control}
These programs are used to enable or disable the
use of a peripheral device.
Disable duplex unit
This program is used to disable duplex printing when
the duplex module malfunctions. If this program is
set, only one-sided printing can be performed.
{Disabling of duplex}
Same as for the main unit.
Disable stapler unit
This program is used to disable stapling when the
stapler unit of the finisher or saddle stitch finisher
malfunctions.
{Disabling of a stapler}
Same as for the main unit.
Disable paper desk drawers
This program is used to disable use of the stand/3 x
500 sheet paper drawer or stand/MPD & 2000 sheet
paper drawer when it malfunctions.
{Disabling of optional paper drawer}
Same as for the main unit.
Disable finisher
This program is used to disable use of the saddle
stitch finisher or finisher when it malfunctions.
{Disabling of finisher}
Same as for the main unit.
Disable mail-bin stacker
This program is used to disable use of the mail-bin
stacker when it malfunctions.
{Disabling of mail-bin stacker}
Same as for the main unit.
Saddle stitch adjust
This program is used to adjust the stapling position
(folding position) when using the saddle stitch
function of the saddle stitch finisher.
The value can be adjusted in 0.1 mm increments
within ±3.0 mm from the reference position for each
paper size.
{Saddle stitch position adjust}
Same as for the main unit.
1
2
12
11
Min. -3 mm Max. +3 mm
Reference position
Position adjusted
to the plus
direction Position adjusted
to the minus
direction
High speed stacking
This program is used to have print speed priority,
which is available for printing in the offset mode with
the saddle stitch finisher.
When this program is on, slight decrease of stacking
performance might occur.
This program is set in the factory default setting.
{High speed stacking}
Same as for the main unit.
Print key operator programs list
This program is used to print out the list of the key
operator programs.
{List print}
Key operator programs for copier, facsimile feature,
and network scanner features can be printed.
■
Key operator code change
This program is used to change the key operator
code.
The key operator must register a key operator code
number and use the number to gain access to key
operator programs. Only one key operator code
number can be registered. The factory has registered
five zeros as the code number to allow initial access
to the programs. It is recommended that the key
operator use the factory number for initial entry into
the programs and then choose and enter another
number by this program.
{Key operator code change}
Same as for the main unit.