imagistics im3510, Operation Manual

Page: 114 / 128

7-4
KEY OPERATOR PROGRAMS
Structure of the setting method for key operator programs
The sequence for selection and setting of key operator programs are shown below. The [OK] and [BACK/C] keys allow
navigation in either direction through the setting steps along a program setting path. Program steps start from the
major categories shown at the left side of the chart and progress to the right.
When the [OK] key is pressed, a highlighted parameter shown in that step will be accepted and set. Acceptance of a
parameter by [OK] will also advance the program to the next step of the setting procedure. When [OK] is pressed to
register all settings at the final step of a setting procedure, the total program will be registered and the screen will
return to display of the major program categories.
The [BACK/C] key is used to return to the previous screen. Successive pushes of the back key will return step by step
back through the setting steps. Settings for any step can be changed by going back and selecting again.
The [ ] and [ ] keys are used to move up and down through selections on a setting screen to highlight a desired
selection. A press of the [OK] key will register the highlighted selection.
A setting value on any setting screen containing an asterisk indicates the current registered value for that parameter.
If a mistake is made in selection, press the [BACK/C] key to return to the selection screen for correction.
On this chart, settings accompanied by an asterisk in parentheses (*) indicate the factory default setting for that
parameter.
NOTE
To exit the key operator program, press the [MENU] key on the operation panel.
Key operator code entry
[BACK/C]
[OK]
[BACK/C]
[OK]
[BACK/C]
[OK]
[BACK/C]
[OK]
[BACK/C]
[OK]
[BACK/C]
[OK]
[BACK/C]
[OK]
ACCOUNT CONTROL
ENERGY SAVE
OPERATION PANEL SETTINGS
DEVICE SETTINGS
KEY OPERATOR CODE CHANGE
SYSTEM SETTINGS
PRODUCT KEY
SET CODE
AUTO POWER SHUT-OFF TIMER (60 min.
*
)
PREHEAT MODE (NO
*
)
TONER SAVE (OFF
*
)
AUTO POWER SHUT-OFF (ENABLE
*
)
PRINT KEY OPERATOR PROGRAMS LIST
AUTO CLEAR SETTING (60 sec.
*
)
MESSAGE DISPLAY TIME (6 sec.
*
)
DISABLING OF BYPASS PRINTING (NO
*
)
LANGUAGE SETTING
(AMERICAN ENGLISH
*
)