Gasoline
Oil
1L
25ml
5L
125ml
Dispose of empty mixing-oil canisters only at authorized
disposal locations.
Fueling
Before fueling, clean the filler cap and the area around it
to ensure that no dirt falls into the tank.
Always thoroughly shake the mixture in the canister be-
fore fueling your machine.
In order to reduce the risk of burns or other per-
sonal injury from escaping gas vapor and fumes,
remove the fuel filler cap carefully so as to allow
any pressure build-up in the tank to release slowly.
After fueling, tighten fuel cap as securely as pos-
sible by hand.
Starting / Stopping the Engine
Starting
1 Put the stop switch in the position ‘1’‘1’
2 Slide the choke to position ‘start’. This is not required
in case of a warm start.
3 Push the fuel pump 6 times.
4 Push the starter rope 2-3 times, to start the motorit is
required to evenly, quickly pull the rope.
5 Slide the chock to RUN positon, slightly push the throt-
tle trigger and pull the starter rope again until the mo-
tor starts running. To push the throttle trigger(1) it is
necessary to first push the locking lever(2).
1
2
6 Let the motor idle for about 10 seconds to warm up.
7 If the motor does not start please repeat the upward-
steps.
Stopping
1 Release the throttle trigger. Let the engine idle. push-
the ignition switch to position “stop”. The engine will
now stop
.
GB-12
