Configuration via OSD
Draco tera flex
68
Field
Entry
Description
Auto Save
Y
Save the current configuration of the matrix in the flash memory
periodically.
Note:
During the save operation, the matrix will not react to
commands. Saving takes place every 600 seconds if changes of
the configuration or switching operations have been executed in
the meantime.
N
Function not active (default)
Enable COM Echo
Y
Send all switching commands performed in the matrix as an
echo via serial interface.
Note:
This function should be enabled when using a media
controller via serial interface.
N
Function not active (default)
Enable LAN Echo
Y
Send all switching commands performed in the matrix as an
echo via LAN connection.
Note:
This function should be enabled when using a media
controller via LAN connection or when using stacking with two or
more matrices.
N
Function not active (default)
Enable Redundancy
Y
Automatically switch to the second link of a connected
redundant CON Unit when losing the primary link of a CPU Unit
(default).
Note
: This function will have to be activated:
•
for a single matrix when using redundant link connections,
•
for both matrices in a fully redundant setup.
N
Function not active
Synchronize
Y
Synchronize the sub matrix to the switch status of the master
matrix.
N
Function not active (default)
Echo Only
Y
Synchronize the matrix according to the echo of a second
matrix.
Note:
This is a bidirectional synchronization where both
matrices have to be configured as
Synchronize
with the
Master
IP
of the respective other matrix.
N
Function not active (default)
Master IP Address
Byte
Set the network address of the master matrix (default:
000.000.000.000)
Invalid IO-Boards
Y
Keep I/O boards with incorrect or invalid firmware online in the
matrix.
Note
: To keep an I/O board with wrong or damaged firmware
online in the matrix, the maintenance mode of the matrix will be
activated.
N
Shut down I/O boards with incorrect or invalid firmware
automatically (default).
Enable old Echos
Y
Translate current switching command (implemented since
V02.09) internally into the old, already known switching
commands and send them as echo.
N
Function not active (default)
