iET PRS-330 series, Operation Manual, Page: 42 / 67

PRS-330 Series
ETHERNET INTERFACE OPTION
30
Figure 4-8 VXI-11 Con fi guration Utility
(Showing all configuration choices with no
changes)
7. When the link has been created, device model
number(s) will appear in the ‘Select Device to
be Con
fi gured’ box. Highlight the desired model
number and click the Con fi gure key to start the
con fi guration process.
8. The Con fi guration Choices box displays only
one line with the fi rst parameter to be changed
and its current setting. If you like the current
setting, click Enter to advance to the next
parameter. If you want to change the setting, type
a new value in the New Value box and click Enter.
The program will send your setting to the board
and read back the new setting. Repeat as needed
to make another change or click Enter again to
advance to the next parameter.
9. Repeat step 8 for each con fi guration parameter.
Figure 4-8 shows the VXI-11 Configuration
Utility after all parameters have been entered for
a Model 9006. Click the Redo From Start key if
you need to start over or if you want to change
any of the prior settings
10. When done, the Save Con fi guration key is
enabled if you changed any settings. Click the
Save Con
fi guration key to save the values in the
board’s fl ash memory. If you did not make any
changes you can just exit the program.
11. The board has to be power cycled or rebooted
before the con
fi guration changes take affect.
Click the Reboot key to reboot the board and use
the new settings.
12. Press the Exit key to quit the VXI11_con fi
g program.
13. If the IP address was changed to an address
outside the 192.168.1.xxx range in step 3, your
PC’s network settings will have to be changed to
communicate with the board. Exit the VXI11_
con
fi g program and restore the PC’s network
settings.
5.7 Resetting Default Network
Settings
The board can be reset to the default network
settings listed in Table 4-2 at any time by holding
the LAN Reset Key in for 5 seconds while
applying power to the board. Access to this key
is on the rear panel of the PRS-330.