iET PRS-330 series, Operation Manual, Page: 32 / 67

OPERATION
PRS-330 Series
20
Figure 3-8 Remote Communications Settings
There are two selections IEEE and Ethernet.
Highlight the interface and press
ENTER to see
the settings for the interface.
3.4.7.1 IEEE Interface Menu
Highlighting and pressing ENTER on IEEE will
show the menu in Figure 3-9.
Figure 3-9 IEEE Menu
There is only one selection which is IEEE
Address: . Pressing ENTER allows the IEEE
address to be set from 1 to 30.
3.4.7.2 Ethernet Interface Menu
Highlighting and pressing ENTER on Ethernet
will show the Ethernet menu in Figure 3-10.
Figure 3-10 Ethernet Interface Menu
There are 3 selections: IP Address:, Network
Gateway:, Network Mask:, which can be
highlighted and then press ENTER to change the
value of each. Mac Address is set at the factory
and only be changed via remote commands.
NOTE: After changing any Ethernet
con fi gurations, wait 3 seconds for the settings
to save. Power-start the PRS and wait 10 seconds
for the remote control interface to load, then on
the browser attempt to load the welcome page at
the IP address.
3.4.8 About Menu
The About menu shows manufacturer, Model,
Serial number, Firmware (FW), Hardware (HW),
and Reset to Default.
Figure 3-9 About Menu